Entegris PFA valves, filters and gas purifiers
Technical selection of Entegris (USA) products: Integra diaphragm valves, CR4 and CH8 valves, NT4400 flowmeters, GateKeeper and GPS8 purifiers, Wafergard and Torrento X filters, A200 SMIF pods.
Integra 3/4" diaphragm valves
Entegris 3/4" Integra valves handle CMP slurries, high-purity chemicals and ultrapure water. Wetted parts are PFA or PTFE, actuators PVDF or ECTFE, Cv 6.7 to 10.9, pressure up to 551.6 kPa. With a PVDF actuator media reach 165 °C, with ECTFE 38 °C.
- Flow: Cv 6.7–10.9
- Pressure: up to 551.6 kPa
- PVDF actuator: up to 165 °C
- PVDF test: 2.1 million cycles
CR4 and CH8 PFA valves
Compact Entegris valves for wet etch and clean chemicals. CR4 1/4" valves have all-PFA wetted parts, handle 160 °C at 276 kPa and lines of 3/8" or smaller. CH8 valves take media up to 200 °C at 207 kPa, Cv 1.8 to 3.4, for hot sulfuric and phosphoric acids in photoresist stripping.
- CR4: 160 °C at 276 kPa
- CH8: 200 °C at 207 kPa
- CH8 flow: Cv 1.8–3.4
- CH8: over 1 million cycles
InVue NT4400 flowmeters
The InVue NT4400 electronic flowmeter measures flow and pressure of chemicals, DI water and slurries by differential pressure, with no moving parts. Accuracy is 1% of full scale, ranges run from 0–50 mL/min to 0–120 L/min, pressure up to 414 kPa, media 10–65 °C.
- Accuracy: 1% of full scale
- Range: up to 0–120 L/min
- Pressure: up to 414 kPa
- Outputs: two 4–20 mA
GateKeeper GPU gas purifiers
GateKeeper GPU SP70, SP300 and SP600 purifiers serve point-of-use gas lines. Bodies are 316L stainless steel, pressure 0 to 206.8 barg, temperature -20 to 65 °C. SP70/SP300/SP600 flow is 20/100/200 slpm up to 2000 psig and 40/200/400 slpm above. Media match the gas.
- Pressure: 0–206.8 barg
- Temperature: -20 to 65 °C
- SP600: 400 slpm above 2000 psig
- Body: 316L stainless steel
GPS8 nitrogen gas purifiers
GPS8 units are auto regenerable bulk nitrogen purifiers removing H2O, O2, CO, CO2 and H2. Two adsorber vessels alternate between purify and regeneration under a microprocessor controller. Model flows run from 10 to 20,000 Nm3/hr.
- Flow: 10–20,000 Nm3/hr
- Pressure drop: below 0.7 bar
- Outlet O2: below 0.1 ppb
- Adsorbers: two, alternating
Wafergard gas filters
Wafergard filters retain particles from 0.0015 µm in ultrapure gas lines. A PTFE membrane on a molded PFA support sits in an electropolished 316L housing. II F Mini XL takes inlet up to 20.7 MPa with 9 LRV at 100 slpm; SG Max is rated 6.0 MPa, up to 1000 slpm, 9 LRV at 500 slpm.
- Retention: from 0.0015 µm
- II F Mini XL: up to 20.7 MPa
- SG Max flow: up to 1000 slpm
- Membrane: PTFE on PFA
Torrento X liquid filters
Torrento X filters serve acid, base and cleaning chemistries, including H2SO4, H3PO4 and HNO3. The nondewetting PTFE membrane sits on PFA supports and shell, with 2, 7 and 10 nm retention ratings. Cartridge and Chem-Line filters run up to 200 °C, the FlowPlane 7 nm version up to 150 °C.
- Retention: 2, 7 and 10 nm
- Cartridges: up to 200 °C
- FlowPlane 7 nm: up to 150 °C
- PTFE membrane, PFA shell
A200 SMIF pods for 200 mm wafers
A200 SMIF pods protect 200 mm wafers in transport and storage and suit automated handling. The shell is polycarbonate and the static dissipative door is carbon-filled polycarbonate. Base is 283 × 292 mm, empty pod weight 2.59 kg, design conforms to SEMI E19.4.
- Wafers: 200 mm
- Base: 283 × 292 mm
- Empty pod: 2.59 kg
- Standard: SEMI E19.4
Choosing Entegris products
Entegris, headquartered in Billerica, Massachusetts, traces its roots to Fluoroware, founded in 1966, and makes components for ultrapure liquids and gases: PFA and PTFE valves, flowmeters, liquid and gas filters, gas purifiers and wafer carriers.
It merged with Mykrolis in 2005, acquired SAES Pure Gas in 2018 and CMC Materials in 2022.
Chemical and CMP slurry lines use 3/4" Integra diaphragm valves with Cv 6.7 to 10.9 and compact CR4 and CH8 valves; the InVue NT4400 measures flow and pressure with two 4–20 mA outputs.
Valves are chosen by media temperature: CR4 up to 160 °C at 276 kPa, CH8 up to 200 °C at 207 kPa, 3/4" Integra with a PVDF actuator up to 165 °C.
Gas purification and filtration
Point-of-use lines take GateKeeper GPU SP70, SP300 and SP600 purifiers with 316L stainless steel bodies rated 0 to 206.8 barg; the purification media is chosen for the gas. Bulk nitrogen is handled by GPS8 units with two alternating adsorber vessels, from 10 to 20,000 Nm3/hr.
Wafergard filters retain particles from 0.0015 µm: II F Mini XL takes inlet up to 20.7 MPa and SG Max is rated 6.0 MPa with flow up to 1000 slpm. Acids and bases go through Torrento X liquid filters with 2, 7 and 10 nm ratings.
Valve maintenance and repair kits
For Integra valves Entegris offers repair kits, complete rebuild kits and tools; CR4, CH8 and CR8 valves have their own repair kits. A Dymension manifold valve is replaced with kit SG4-2C-DMB-RKIT, then the actuator is tested at 483 kPa and the seal with 552 kPa air.
The Integra maintenance guidelines call for checking the leak port, pilot pressure and fitting torque, cycling normally static valves and considering replacement of valves more than five years old.
Entegris and model names are trademarks of their respective owners and are used only to identify the equipment for which we source parts. SpareX is not an official dealer, distributor or representative of Entegris and is not affiliated with the trademark owner. Origin, documents and warranty are stated for each item in the quotation.
Related equipment manufacturers
- Equipment and parts for Valex
- Equipment and parts for Veeco
- Equipment and parts for Axcelis Technologies
- Equipment and parts for Alicat Scientific
- Equipment and parts for MDC Precision
Documents and sources
- Home page — catalog and services
- Corporate overview — history and headquarters
- 3/4" Integra valves — data sheet
- Integra valves — preventive maintenance guidelines
- CR4 Series valves — data sheet
- CH8 Series valves — data sheet
- Dymension manifold valves — repair instructions
- Integra valve repair and tool kits
- CR4, CH8 and CR8 valve repair kits
- InVue NT4400 flowmeter — data sheet
- GateKeeper GPU SP purifiers — data sheet
- GateKeeper GPU gas purifiers — series page
- GPS8 nitrogen purifiers — data sheet
- Gas filters — product overview
- Wafergard SG Max gas filters — data sheet
- Wafergard II F Mini XL gas filters — data sheet
- Torrento X filters — data sheet
- A200 wafer SMIF pods — data sheet
