STAMO industrial agitators and parts
STAMO Agitation Solutions top mounted, side mounted and angled agitators. Configure complete equipment, impellers, shaft supports and seals for the process tank.
STAMO top mounted agitators
Top mounted agitators use direct, geared, belt, air or hydraulic drives. The impeller and shaft are configured for the process. Bearing arrangements and shaft seals depend on the selected design.
- Top mounting
- Direct or geared drive
- Single mechanical seal
- Double mechanical seal
STAMO side mounted agitators
Side mounted agitators enter through the tank wall. Geared, belt, air and hydraulic drives are available. Shaft seals and an optional support to reduce tank flange loads form part of the configured assembly.
- Side entry
- Mounting plate or stand
- Optional flange load support
- Mechanical seals
Angled and adjustable agitators
Angled agitators use a geared drive and one or two propellers. A bottom bearing stabilises the shaft. The adjustable design uses a stand with variable angles and a double mechanical seal.
- Geared drive
- Angled installation
- Bottom shaft support
- Adjustable stand
STAMO standard agitators
The standard range includes Propconemixer, adjustable, container and barrel agitators. Container units use a frame, plate or lid mounting. Fixed or folding impellers are selected for the specific configuration.
- Propconemixer units
- Container agitators
- Barrel mixers
- Adjustable agitators
STAMO propellers, turbines and discs
Impellers include the 2A anchor and 2G, 2GN, 2GND, 3GN, 3GNB, 3M and 4GN propellers. Folding designs are labelled 3GF and 4FB. Turbines and the ZA dispersing disc cover further process configurations.
- 4/6RFT Rushton turbine
- 4SPT spiral turbine
- 4AFT axial flow turbine
- 6RC gas dispersion turbine
Shaft supports and stabilisation
STAMO shaft support options include a catch ring, slide bearing and bottom bearing. These components support the shaft and limit excessive vibration. Slide bearings are available with different material options.
- Catch ring
- Slide bearing
- Bottom bearing
- Bearing material options
Agitator selection and configuration
STAMO agitator configuration depends on mounting, process media and tank geometry. STAMO Agitation Solutions offers top mounted, side mounted, angled and adjustable designs, alongside standard units for containers and barrels.
The project defines the drive, mounting, shaft, impeller, bearing arrangement and shaft seal. These options belong to a configured system rather than a set of universally interchangeable components.
Materials and impeller configuration
Manufacturer material options include stainless steels 1.4301 and 1.4404, duplex steels, titanium and Hastelloy C276/C22. Rubber, polyurethane and ceramic linings are available for selected configurations.
Propellers, turbines, anchors and dispersing discs address different process arrangements. A project may cover a complete agitator or matched components for equipment already installed.
STAMO and model names are trademarks of their respective owners and are used only to identify the equipment for which we source parts. SpareX is not an official dealer, distributor or representative of STAMO and is not affiliated with the trademark owner. Origin, documents and warranty are stated for each item in the quotation.
