THK linear guides, ball screws and motion assemblies
THK motion components for industrial equipment: linear guides, ball screws and KR/SKR modules. Assembly selection by load and mounting arrangement.
Ball-type LM Guide units
A rail and carriage form the linear guiding unit. THK offers caged-ball and full-ball designs. Replacement selection considers the block configuration, matching rail and preload.
- LM rail and block
- Caged-ball designs
- Full-ball designs
- Matched axis assembly
Roller-type LM Guide units
The LM Guide range also includes roller guides. THK distinguishes caged-roller and full-roller structures. Selection follows the specific axis design rather than rail width alone.
- Linear guidance
- Roller elements
- Caged-roller designs
- Full-roller designs
Ball screws and BNK assemblies
A ball screw converts rotary motion into linear travel through its shaft and nut. The BNK range has finished shaft ends. Selection includes the screw lead, shaft-end geometry and bearing arrangement.
- Screw shaft and nut
- BNK range
- Finished ends on BNK
- Support arrangement
Ball screw support units
THK offers standardized BK and BF support units for ball screws. Fixed and supported ends have different functions in an axis. Replacement selection checks shaft fits, axis height and housing attachment.
- BK and BF units
- Fixed-end support
- Supported end
- Shaft-fit matching
Ball spline assemblies
A ball spline transmits torque while permitting linear travel. Its shaft and spline nut work with circulating balls. Assembly selection considers torque, applied load and the nut mounting arrangement.
- Torque transmission
- Linear travel
- Spline shaft
- Recirculating balls
KR and SKR linear actuators
KR and SKR integrate linear guides with a ball screw. The guide raceways sit beside the central screw in a U-shaped outer rail. We select the actuator assembly and match its mechanical connection to the axis.
- KR and SKR ranges
- Integrated guide and screw
- U-shaped outer rail
- Axis assembly selection
Cross-roller rings
Alternating roller orientation allows a ring to carry loads in different directions. The bearing accepts radial, axial and moment loads. Replacement selection checks the mounting arrangement and required rotary accuracy.
- Roller bearing
- Radial load
- Axial load
- Moment load
Linear bushings and shafts
A THK linear bushing runs on a cylindrical LM shaft. The pair provides guided linear movement. Replacement selection checks shaft diameter, bushing dimensions and the way the bushing is retained in its housing.
- Cylindrical LM shaft
- Guided linear travel
- Bushing and housing
- Mounting verification
Selecting a THK motion assembly
The assembly is selected by load, accuracy and axis mounting arrangement. A rail guide requires a matched block, rail and preload specification; a ball screw requires a shaft, nut and supports. KR/SKR modules combine guides with a screw drive.
We record the agreed configuration in the project specification.
Linear travel and torque transmission
Ball splines transmit torque while allowing linear travel. Linear bushings run on cylindrical shafts. Cross-roller rings serve rotary assemblies subject to radial, axial and moment loads. These components perform different tasks and need separate mounting checks.
THK and model names are trademarks of their respective owners and are used only to identify the equipment for which we source parts. SpareX is not an official dealer, distributor or representative of THK and is not affiliated with the trademark owner. Origin, documents and warranty are stated for each item in the quotation.
