R&D Dynamics turboexpanders, turboalternators and blowers

Technical selection of R&D Dynamics (USA) foil bearing turbomachinery: TurboEx turboexpanders, turboalternators, blowers and compressors, turbocompressors, CENVA compressors and an ORC system.

Foil air and gas bearings

Self-generating, compliant hydrodynamic bearings: the shaft of an oil-free high speed machine rides on a thin air or gas film. A pair of journal bearings gives radial support, a pair of thrust bearings takes the axial load. Journal sizes run from 0.375 to 6 inches, thrust from 0.80 to 9.00 inches.

  • Journal: 0.375–6 in
  • Thrust: 0.80–9.00 in
  • Foils: solid film lubricant
  • Set: 2 journal and 2 thrust

Motor driven blowers and compressors

High speed blowers with a pressure ratio below 2.0 and compressors above 2.0, from 100 watts to over 100 kW, all on oil-free foil air/gas bearings. They compress air, neon and methane and serve particle transport such as cement, wastewater treatment, pharmaceuticals and food processing.

  • Size: 100 W to over 100 kW
  • Blowers: pressure ratio below 2.0
  • Compressors: ratio above 2.0
  • Gases: air, neon, methane

Fuel cell blowers

Foil bearing blowers for fuel cell cathode, anode, fuel and recycle duty. They are driven by a permanent magnet synchronous motor with optimized sensorless vector control. The high-temperature recycle blower handles gas as hot as 850 °C, and its motor is hermetically sealed.

  • Recycle gas: up to 850 °C
  • Recycle motor: hermetically sealed
  • Motor: permanent magnet synchronous
  • Control: sensorless vector

TurboEx turboexpanders

TurboEx turboexpanders on foil gas bearings serve air separation, oil and gas processing, gas liquefaction and cryogenic refrigeration. They range from 1 to 400 kW with flows from 200 to 80,000 lbs/hr. TurboEx models are compressor loaded, from TurboEx 127 to TurboEx 1000.

  • Power: 1–400 kW
  • Flow: 200–80,000 lbs/hr
  • TurboEx 127: 1–7 kW
  • TurboEx 1000: 150–400 kW

Foil bearing turboalternators

High speed turboalternators from less than 5 kW to 400 kW convert the energy stored in a process gas to electric power. The generator is shaft mounted, so no gearbox is needed. Uses include air separation plants, pressure letdown stations, compressed air energy storage and ORC systems.

  • Power: below 5 kW to 400 kW
  • Generator: shaft mounted, no gearbox
  • TurboAlt models: generator loaded
  • Air energy storage unit: 10 kW

Turbine-driven turbocompressors

Oil-free turbocompressors on foil air bearings, driven by a turbine. They pressurize fuel cell systems and serve as turbochargers for automobiles and trucks. R&D Dynamics has built a fuel cell turbocompressor with a rotor weight of 150 lb.

  • Drive: turbine
  • Bearings: foil air bearings
  • Rotor: up to 150 lb
  • Duty: fuel cell pressurization

CENVA vapor cycle compressors

The CENVA family of energy efficient vapor cycle compressors serves industrial and commercial air conditioning and refrigeration systems. Sizes run from 10 to 100 tons of refrigeration capacity, all on oil-free foil gas bearings. Options: R-134a or R245fa refrigerant, liquid or air cooling.

  • Capacity: 10–100 refrigeration tons
  • Refrigerants: R-134a, R245fa
  • Cooling: liquid or air
  • Chillers: water or air cooled

AdvancedPower 170 kW ORC system

The AdvancedPower 170 kW Organic Rankine Cycle system generates electricity from low grade waste heat. At its heart is a foil gas bearing supported turboalternator, and the system is completely oil-free. Heat sources include gas turbine exhaust, commercial ovens, diesel engines and other processes.

  • Power: 170 kW
  • Cycle: Organic Rankine
  • Generator: oil-free turboalternator
  • Heat: turbine exhaust, diesels, ovens

Choosing R&D Dynamics turbomachinery

R&D Dynamics Corporation, Bloomfield, Connecticut, USA, was founded in 1990 and builds oil-free high speed turbomachinery on foil air/gas bearings: turboexpanders, turboalternators, turbocompressors, motor driven blowers and compressors, CENVA vapor cycle compressors and ORC systems.

Air separation, gas processing, liquefaction and cryogenic refrigeration use TurboEx turboexpanders of 1 to 400 kW with flows of 200 to 80,000 lbs/hr. Turboalternators up to 400 kW turn process gas energy into power, and the AdvancedPower 170 kW ORC system recovers waste heat.

TurboEx and TurboAlt model range

TurboEx models are compressor loaded, TurboAlt models generator loaded. TurboEx power by model: 127 — 1–7 kW, 215 — 5–20 kW, 330 — 15–50 kW, 411 — 25–75 kW, 540 — 45–115 kW, 630 — 60–160 kW, 800 — 100–250 kW, 1000 — 150–400 kW.

Existing designs are used whenever possible and modified for the application. Sizing is based on gas type, inlet and outlet temperature and pressure, and power or flow.

Blowers, compressors and CENVA

Blowers with a pressure ratio below 2.0 and compressors above 2.0 range from 100 watts to over 100 kW, for fuel cells, air, neon and methane compression, cement transport and wastewater treatment. The high-temperature fuel cell recycle blower handles gas up to 850 °C.

CENVA vapor cycle compressors cover 10 to 100 tons of refrigeration capacity with refrigerants including R-134a and R245fa.

Industrial equipment

Request a quote

Describe your requirements and attach up to 5 files, each up to 20 MB.

You can also drag photos or documents here.

You can also email us. Opening your email app does not send an enquiry automatically.

WeChat · Nastia

English-speaking contact

WeChat QR code: Nastia

Scan the QR code to add Nastia on WeChat.

Save QR image

On this phone: save the image, then choose it from your photos in WeChat’s scanner.

Telegram · Nastia

Contact Nastia

Telegram QR code: @ananasprosto

Scan the QR code or open @ananasprosto in Telegram.@ananasprosto в Telegram.

Save QR image

Scan the QR code or open @ananasprosto in Telegram.