Texas Instruments ICs and components

Select Texas Instruments analog ICs and embedded controllers for industrial electronics by function, package and electrical requirements.

OPA197 precision amplifiers

OPA197 is a precision operational amplifier for a total voltage up to 36 V. Its input and output operate near the rails. Selection depends on signal range, feedback network and output loading.

  • Up to 36 V
  • Precision amplifier
  • Rail-to-rail input
  • Rail-to-rail output

ADS1115 analog-to-digital converters

ADS1115 is a 16-bit delta-sigma ADC with an I2C interface. It integrates a PGA, reference and comparator. Its four-channel input multiplexer and programmable conversion rate suit compact measurement circuits.

  • 16-bit resolution
  • Up to 860 SPS
  • Four input channels
  • I2C interface

LM2596 step-down regulators

LM2596 is a step-down switching regulator for 4.5–40 V input and loads up to 3 A. Fixed and adjustable output versions are available. Inductor, diode and capacitor selection determine the complete power stage.

  • 4.5–40 V input
  • Up to 3 A load
  • Step-down topology
  • Adjustable versions

ISO7741 digital isolators

ISO7741 is a four-channel digital isolator with a 3/1 direction arrangement. It separates digital circuits across an isolation barrier. Package, power domains and default output state distinguish orderable versions.

  • Four channels
  • 3/1 directions
  • Digital isolation
  • Package variants

DRV8871 brushed motor drivers

DRV8871 drives a brushed DC motor through an H-bridge with PWM inputs. Integrated current regulation avoids an external current-sense resistor. The current-setting network and thermal path form part of the drive design.

  • Brushed DC motor
  • PWM control
  • Integrated current sensing
  • H-bridge output

C2000 real-time controllers

TMS320F280049C is a 32-bit C2000 MCU with a 100-MHz C28x core. It combines a CLA accelerator with control peripherals and CLB logic. Firmware, pin assignment and peripherals must match the target control board.

  • C28x core
  • 100-MHz clock
  • CLA accelerator
  • CLB logic block

LP2985 low-dropout regulators

LP2985 is a low-dropout linear regulator rated for up to 150 mA. An enable input controls operation. Output voltage and orderable variant must match the local power rail and the surrounding capacitor network.

  • Up to 150 mA
  • Linear regulation
  • Low dropout
  • Enable input

SN65HVD230 CAN transceivers

SN65HVD230 is a 3.3-V CAN transceiver with a standby mode. It connects controller logic to a differential bus. Selection covers logic compatibility, operating mode and the protection network of the complete interface.

  • 3.3-V operation
  • CAN interface
  • Standby mode
  • Differential bus

Selecting ICs for industrial electronics

Texas Instruments develops analog ICs and embedded processing devices. Selection follows the circuit function: signal conditioning, conversion, power regulation, isolation, motor control or communication. The component is assessed within its board, load and thermal environment.

Analog signal-chain compatibility

OPA197 and ADS1115 serve different stages of a measurement chain. The amplifier must match signal levels and loading; the ADC must match input configuration, PGA settings and I2C communication. Individual device limits do not establish the accuracy of a complete channel.

Power rails and motor loads

LM2596 provides switching step-down regulation, while LP2985 provides linear regulation. DRV8871 is a separate power stage for brushed DC motor control. External components, load current and thermal conditions determine suitability.

Control, isolation and communication

TMS320F280049C combines a processing core and control peripherals. ISO7741 separates digital domains; SN65HVD230 connects a controller to CAN. Board compatibility depends on the circuit and its firmware.

Texas Instruments and model names are trademarks of their respective owners and are used only to identify the equipment for which we source parts. SpareX is not an official dealer, distributor or representative of Texas Instruments and is not affiliated with the trademark owner. Origin, documents and warranty are stated for each item in the quotation.

Related equipment manufacturers

Documents and sources

Industrial equipment

Request a quote

Describe your requirements and attach up to 5 files, each up to 20 MB.

You can also drag photos or documents here.

You can also email us. Opening your email app does not send an enquiry automatically.

WeChat · Nastia

English-speaking contact

WeChat QR code: Nastia

Scan the QR code to add Nastia on WeChat.

Save QR image

On this phone: save the image, then choose it from your photos in WeChat’s scanner.

Telegram · Nastia

Contact Nastia

Telegram QR code: @ananasprosto

Scan the QR code or open @ananasprosto in Telegram.@ananasprosto в Telegram.

Save QR image

Scan the QR code or open @ananasprosto in Telegram.