Industrial Adhesives and Sealants Akfix / Akkim

Application procedure for Akfix 705 two-component fast adhesive with aerosol activator

Achieving maximum bond strength with Akfix / Akkim series 705 requires disciplined sequential component application. Joint surfaces must be cleared of dust, oil, and moisture prior to bonding.

A bead of high-viscosity cyanoacrylate gel is applied to one mating face, while the opposing substrate receives a uniform aerosol activator spray from six inches away. Following flash-off of the carrier solvent, components are joined and held under firm pressure for eight to ten seconds.

The thixotropic gel prevents sagging on inclined surfaces, while the activator guarantees dependable curing across porous timber and MDF.

Insulation board montage and gap sealing using Akfix 805P and 850 Mega foams

Thermal insulation and perimeter sealing routines with Akfix / Akkim 805P and 850 Mega polyurethane foams depend heavily on ambient temperature and humidity.

The aerosol container should be acclimated at room temperature for twelve hours and shaken vigorously for thirty seconds prior to gun assembly. Substrate surfaces must be misted with water because polyurethane prepolymer curing is driven by atmospheric moisture.

Joint filling proceeds upward in zigzag motions covering one-third of gap depth, providing space for controlled expansion without bowing door frames or wallboards.

Sealing expansion joints and equipment flanges with Akfix HT300 and P645

Joint sealing integrity across expansion seams and pipe flanges using Akfix / Akkim HT300 and P645 depends on joint geometry and surface cleaning. In moving building joints, width-to-depth ratio must maintain a two-to-one proportion over closed-cell polyethylene backer rod.

This avoids three-point adhesion and allows the polyurethane elastomer to flex under thermal movement. When creating formed-in-place gaskets with high-temperature silicone HT300, a continuous bead circles bolt holes with ten minutes open skin time prior to metal assembly torque.

Montage of heavy cladding panels using All Bond MS High Tack hybrid polymer

Structural mounting of heavy architectural panels with Akfix / Akkim All Bond MS High Tack eliminates mechanical fasteners across vertical walls. Adhesive beads are dispensed in vertical strips spaced four to six inches apart utilizing a specialized V-notch applicator nozzle.

Circular or closed-ring adhesive beads must be avoided because they hinder ambient moisture entry toward the center of the joint. Components are pressed home firmly with slight sliding motion, where immediate green grab holds the heavy element securely against gravity.

Cleaning and corrosion protection using Akfix A40 Magic and E70 technical sprays

Maintenance of factory machinery utilizing Akfix / Akkim aerosol products A40 Magic and E70 restores rusted linkages and cleans sensitive electrical terminals.

Penetrating fluid A40 is directed into seized threads and guide bushings, where low surface tension draws the lubricant into microscopic clearances to dissolve rust within minutes.

For cleaning circuit breakers and switchgear, solvent cleaner E70 flushes varnish and grease without leaving conductive residues, preserving dielectric insulation properties.

Threadlocking and cylindrical joint retention with Akfix L242 and R306 anaerobics

Retaining critical fasteners and cylindrical bearing fits with Akfix / Akkim anaerobic adhesives L242 and R306 stops vibration loosening in plant machinery. Fastener threads must be degreased prior to applying several drops of liquid monomer across initial engagement threads.

Polymerization begins immediately when air is excluded between tightened metal surfaces. Functional strength develops within fifteen to thirty minutes, reaching complete chemical cure into a durable thermoset polymer within twenty-four hours.